note: howto use LGPROG under Windows
XP SP3 (english)
comment utiliser le logiciel LGPROG sous windows
XP SP3 (fr)
comment utiliser le logiciel LGPROG sous
windows XP SP3
notice utilisation
ELAN5000 (PDF- 39 pages -557 Kb)
notice LGPROG (PDF - 9 pages - 201
Kb)
fichier batch instal.bat
here
download the Elan 5000 Series Manual (69 pages / Archive size 9,7 Mbytes)
5000series (5.94Mb)
ELAN Shortform in color (6.83Mb)
base5000 (1.28Mb)
here download
the software Exfile to communicate with a PC via the RS232. (190 Kb)
Set the programmer in remote mode "remote exfile" by pressing "Shift+Enter" and after that start the software; then this software will test the port at various speeds and then when it find the right speed the software can operate normally.
positionner le programmateur en mode " remote exfile" au moyen
des touches "shift + enter". Et aprés seulement lancer le
logiciel qui va tester le port a toutes les vitesses pour ecouter un "echo"
du prog. Lorsqu'il le trouve il entre dans le "phase active du programme".
Il liste les "devices" accessibles et taches habituelles "read,
programm, verify, check..." Programme trés rudimentaire. Pas posible
de faire copie d'écran car j'ai été obligé de
le demarrer avec une disquette DOS...
Le prog ne passe pas à travers XP..
here Télécharger la version française
LGPROG du programme de communication avec le programmateur ELAN (176Ko)
firmware for the Elan 5000 (non-turbo) they are for EPROM ZIFPAC
EFPER E4.0I for the 932 ZIFPAC (ZIP Archive
- 130Kb)
7.05 firmware (binary file - 256Kb) for
the EPROM ZIFPAC non-turbo for a 27C020.
The cartridge label said 7.03 but the EPROM had been upgraded to 7.05.
There are two versions of the module PCB. The older version can only use
up to the 27C010 and pin 30 (NC) is connected to +5V. The later version can
use the 27C020 and pin 30 (A17) is connected to pin A7 on the DIN41612 connector.
This should explain why some module firmware did not run correctly ; see the
Elan 5000 page http://baddinsbits.altervista.org/e5000.html
intel Hex format 7.05 firmware (HEX- 721Kb)
******
Si vous recherchez des informations pour ce programmateur, vous pouvez me contacter par e-mail : matthieu.benoit@free.fr . De même si vous avez des informations sur ce programmateur, n'hésitez pas à contribuer à cette page.
M-à-j: 1 août, 2017.